Cookie settings

Choose which optional cookies we can use. You can change this at any time from the link at the foot of every page.

Case study

Case Study – underfloor heating installation using Profix panels

By Anders

Underfloor heating supply and fit project completed by ourselves in Eckington, Pershore, Worcestershire.

Project type: Ground floor – ufh to new extension and also to existing parts of the ground floor.

Heat source: Boiler

Pipe centres: 150 mm cc

Installation method: Pipe (within new floor screed) clipped onto insulation in new side and rear extension, pipe within profix panels (above concrete) with self levelling compound in existing parts of the ground floor.

Case Study – underfloor heating installation using Profix panels, photo 1 of 12

Manifold used: A 10-circuit Watts manifold with a Grundfos UPS2 pump and Reliance mixing valve

Case Study – underfloor heating installation using Profix panels, photo 2 of 12 Case Study – underfloor heating installation using Profix panels, photo 3 of 12 Case Study – underfloor heating installation using Profix panels, photo 4 of 12

Day 1: Profix panels fitted onto concrete floor, sikabond glue was used plus also screws and plugs.

Case Study – underfloor heating installation using Profix panels, photo 5 of 12 Case Study – underfloor heating installation using Profix panels, photo 6 of 12 Case Study – underfloor heating installation using Profix panels, photo 7 of 12

Pipe used: Valsir 12 mm Pex/al/pex multuilayer pipe. In the new extension 16 mm pipe was used, as a new concrete floor. It helps to lay down the pipe coil horizontally e.g. onto a pipe decoiler – to reduce anyy pressure building up at the bends (avoid pipe springing up).

Profix panels are 15 mm deep, they came with 3 mm XPS insulation prebonded.

Case Study – underfloor heating installation using Profix panels, photo 8 of 12Case Study – underfloor heating installation using Profix panels, photo 9 of 12 Case Study – underfloor heating installation using Profix panels, photo 10 of 12

System filled with water. Obviously we also adjust the flow rates for each pipe circuit on installation day, to make it as easy as possible to start the ufh at a later date.

Case Study – underfloor heating installation using Profix panels, photo 11 of 12

Rothenberger test pump connected during pressure test at 6 bar ! As you can see we’ve marked up all individual loop lengths on the manifold. It can only be of benefit even in the future to know each circuit length.

Case Study – underfloor heating installation using Profix panels, photo 12 of 12

The Valsir 12mm underfloor heating pipework within the profix panels, was to be covered by levelling compound before a tile floor finish was fitted on top. The customer is really pleased with the performance. However from an installer’s point of view, this is a time consuming way of installing retrofit ufh.

Underfloor Heating Systems Limited supply high quality ufh systems nationwide. For larger projects please forward us your floor plans. For the average house extension project you may find the most suitable kit for you by visiting our online underfloor heating store at:

Pershore underfloor heating installers Worcestershire.

Underfloor heating installers West Midlands

Underfloor heating Pershore

All case studies