Cookie settings

Choose which optional cookies we can use. You can change this at any time from the link at the foot of every page.

News

Valsir Underfloor Heating Pipes

By Leif

Valsir underfloor heating pipes are normally bent without any special tools. When the pipes have been in service and temperature and pressure decrease, the pipe contracts. With an approved fitting range the grip between the pipe and fittings is stronger than the contraction force and does not give any problem provided the installation of the fitting is carried out according to the manufacturers instructions.

Valsir underfloor heating pipes should be connected to the underfloor heating manifolds with approved 16 x 2 mm euroconus fittings, ie PEX/AL/PEX multilayer pipe. The euroconus fittings is made up by a nut, sleeve and an insert.

These euroconus fittings are the most common types of fittings available for underfloor heating manifolds. During the installation follow the manufacturers assembly instructions.

Underfloor Heating Systems Limited only supply 16 mm Valsir pipe for our underfloor heating systems. This size is very common in Europe and works well with all types of floor contructions.

All posts
  • News

    Underfloor Heating Water Flow

    The water in the underfloor heating system must flow in order to convey heat to the floor. The size of the water flow is determined by the amount…

  • News

    Underfloor Heating Loop Patterns

    For underfloor heating water there are three main types of underfloor heating loop configurations. The type of configuration depends on the construction techniques and practices in different countries.

  • News

    Underfloor Heating Automatic Bypass Valve

    Normally the underfloor heating flow rates per underfloor heating water loop is between 1 – 4 l/min. The flow rate for the water underfloor heating system can be…